Configure ZTE ZXHN H267A for TM Streamyx

These steps will guide you through on how to configure ZTE ZXHN H267A modem router for TM Streamyx.

(Note: This guide is based on Software Version: V1.0.0_MYT3A)

1. Connect your laptop to modem via LAN ports. Recommended to use Port 1. If LED for Port 1 is not blinking try other ports.

2. Go to the default main page of the modem by typing http://192.168.1.1 on your internet browser.

3. Login to your modem using tmadmin userid and password.

4. Once you have successfully login, it should direct you to Management & Diagnosis > Service Scenarios. On this page information, under Default Configuration, please make sure the mode setting is set for Router (SUBB). The reboot might be required if the default mode is different.

5. Once the modem is up after the reboot, login again to modem. Then go to Internet > WAN. Under DSL tab, please disable PPPoE_VD since it is for VDSL connection and click Apply button. After that, expand PPPoE_AD, and put in your streamyx login under PPP > Username and enter your streamyx password on PPP > Password. For IP Version, please make sure the value is IPv4 then click Apply button.

6. On the same page, go to DSL Modulation Parameters and expand it. Under Modulation Type Selection, disable VDSL2 (G.993.2) since you are not using it for Streamyx which only using ADSL. Under Enhance Capability, make sure Bitswap and SRA are selected (other option are for VDSL, you can ignore it).

Configuration for the Wifi/WLAN on this modem is pretty straight forward. But do let me know if you guys need me to add the steps on this blog as well.

I am still looking for a link on how to get the latest firmware for this modem. If anyone has an info on that do share with me so that I can update this blog content on how to perform a proper firmware update and how to validate it.